Thank you for your purchase. With the installation of this CARAMORE shield,we hope that you will help prevent any further catalytic converter theft.The included hardware kit will help further secure your customers’ catalytic converter and deter thieves.
Package Contents:
- (8) Rivets
- (6) Security
Screws
- (2) Self
Tapping Screws
- (1)
Aluminum Security Plate
STEP 1: Locate
and remove the front plastic slash shield 10mm nuts shown in red.
The CARAMORE
plate is mounted on the front 3factory studs and the OEM splash guard is
installed over the plate. This allows for the plate to be centered and aligned
with the frame rails on each side. These nuts are kept loose until all other
fasteners are installed. These (3)10mm nuts should be tightened last.
STEP 2: The
provided self-tapping screws to hold the plate in place while drilling the
rivet holes. Place one security screw in any of the red outlined areas. These
areas will house the security screws once the other holes for the rivets have
been drilled.
*We highly recommend using a clearance adjustment tool
when installing the shield. A wood 2×4 or equivalent should be placed between the cat
and the shield prior to installing any permanent hardware. This will ensure the
shield does not rattle.
STEP 3: Alternating sides,drill out the remaining holes. You
can use the self tapping screws or a 3/16"drill bit. Once drilled, alternate sides again and
install the rivets highlighted the red areas.
STEP 4: Install the security screws in the center and outer
holes of the shield.
STEP 5:
Replace the front splash shield and tighter down the (3)10mm nuts.
Remove the clearance tool from between the cat and shield.
Thanks for reading!
No comments:
Post a Comment